LotusElan.net Unified Search
Search results for: ballast resistor in category "Electrical / Instruments"
100 results found containing all search terms.
7 pages of results.
1. ballast resistor : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Okay, so to cut a long thread short, for last 5 months she basically wont start, I have had her running, but again mysteriously stops. ...
... ballast resistor Okay, so to cut a long thread short, for last ... months she basically wont start, I have had her running, but again mysteriously ...
2. Ballast resistor, Elan Sprint : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I cannot find a ballast resistor on the low tension feed to the coil in the Lotus wiring diagram. Is there supposed to be one? ...
... Ballast resistor, Elan Sprint I cannot find a ballast resistor on the low ... feed to the coil in the Lotus wiring diagram. Is there supposed to be ...
3. Ignition ballast voltage drop question : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Been researching ignition ballast for a bit, since it isn’t shown in the Elan +2s Federal wiring diagram, although there is an update addendum, but ...
... Ignition ballast voltage drop question Been researching ignition ballast for a bit, since ... The measurement is not taken on the resistor, but on the supply wire connection ...
4. Ballast resistor? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hello, I seem to have a missfire at high rpm when the engine is hot so I'm suspecting the coil as everything else is new. ...
... Ballast resistor? Hello, I seem to have a missfire at high rpm ... the engine is hot so I'm suspecting the coil as everything else is new. ...
5. Coil voltage : Electrical / Instruments - Page 2 by LotusElan.net [Electrical / Instruments]
I will leave this as clearly you have no idea what you are talking about. There will be no voltage across the capacitor when the ...
... I converted my car back to a ballast setup. I knew I needed to ... coil and ballast resistor as part of that. Based on the "9V coil ...
6. Stubborn misfire : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi I'm having some problems with an annoying misfire. When I reassembled the engine I took the braided earth off the coil bracket and capacitor ...
... high output coil. It has no ballast resistor fitted, which jibes with what ... said here: https://www.autoelectricalspares.co.uk/ .. -100-p.asp - the DLB110 ...
7. Coil voltage : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi all, I know this has been discussed ad naseum, sorry. I recently lost ignition due to the condenser failure. A new condenser got me ...
... . My friend suggested I'm missing the ballast that knocks the voltage down to 9v ... have 1.5 ohm coil and 1.5 ohm resistor, so you get 3 ohms total ...
8. Spare good distributor or coil for sale? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I am attempting to trace a fault that caused Toad to spend another trip on the breakdown truck. lotus-twincam-f39/misfire-then-will-not-pull-hill-t40445.html I've stripped apart the fuel pump ...
... . If it helps i have a Ballast coil i could send you? I ... coil, Quite possibly to a blast resistor to provide ~9V. On a ...
9. Ignition coil has to be grounded? : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
My Sprint has a 3 Ohm (internally ballasted) coil chassis to engine ground strap but still a bit hit see a comment in the coil ...
... Sprint has a 3 Ohm (internally ballasted) coil & I have electronic ignition ... used with an external 1.5 Ohm ballast resistor. This may be an American term. ...
10. No Tacho after accuspark and Ballast resistor : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi, I have a 1972 Elan +2S130 (UK) and I have just made the following changes to try to improve starting; 1. Replaced points with ...
... No Tacho after accuspark and Ballast resistor Hi, I have a 1972 Elan ... 2S130 (UK) and I have just made the following changes to try to ...
11. Starting Problems and overun when switching off!!! : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi all, Just started the process of trying to get the engine started after some 4 years of getting the car rebuilt. I have done ...
... cylinder I have changed coil to non ballast resistor type Compression to each pot is ... per book 160 PSI The problem is that the car turns over fine, floods ...
12. Ballast resistor : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I'm returning my +2 to a ballast resistor coil system the resistor is the long external ceramic type, whereas the original one was a round ...
... Ballast resistor I'm returning my + 2 to a ballast resistor coil system& ... resistor is the long external ceramic type, whereas the original one was a round ...
13. ballast resistor : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Did the Elan and Elan +2 include a ballast resistor from the factory? When rewiring is it advisable to use a non-ballasted coil and + ...
... ballast resistor Did the Elan and Elan + 2 include a ballast resistor from ... factory? When rewiring is it advisable to use a non-ballasted coil and "+ " ...
14. Barking mad on starting : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
IMG_2841.jpeg IMG_2841.jpeg Problem starting +2 s130/4 April 1972 I’ve not got much recent history. It’s coil / solenoid wiring problem I think as I’ve got ...
... old pictures showing what looks like a ballast resistor fitted on the coil but not ... the engine was refitted. I've got a white / yellow to the+ side ...
15. Strange ignition problem : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
So here's my problem, There isn't a fuel delivery problem and I do have spark (albeit slightly weak), and when the car is running it ...
... for. Rokkbert DO you have a ballast resistor? Ignition switch? gus You ... . The coil does have an internal resistor and I'm getting a lower voltage than ...
Search took 0.235 seconds