LotusElan.net Unified Search
Search results for: c clip slave in all categories
The following word(s) are in the skip word list and have been omitted from your search: "c"
103 results found containing all search terms.
Refine your search by category:
- Wiki (2)
- Classifieds (10)
- Mailing List Archive (11)
- General (17)
- Body / Chassis / Frame (1)
- Drive Train / Gearbox / Final Drive (51)
- Electrical / Instruments (2)
- Engine / Exhaust / Cooling (7)
- Mods (1)
- Misc. (1)
6 pages of results.
Sorted by relevance / Sort by date
Glen, you kill me! i only used the saws-all to cut the 4 bolt length to the required 3 3/4 length. Not for cutting the ...
... are too long and the pin retaining clip holes are in the wrong place. ... on the hydraulics (brakes and clutch slave and master cylinders) . After that ...
82. Over Rev : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
I had an incident were the throttle return spring migrated across and caught on the side of the rear carb bracket. I have Weber 151's ...
... arm hole and could see the 3 clips in place. I must admit that ... Y " piece and changed the clutch slave cylinder rubbers as the boot on that ...
83. Clutch hydraulics route : Archive by LotusElan.net [Mailing List Archive]
Does the route for the hydraulic pipework for the clutch go over, or under, the bellhousing? Ours goes over, but looking at the drawing in ...
... bolt of the bell housing by a clip that the hydralic hose pressed into.. at ... over the bellhousing..and then down to the slave cylinder. Tony V http:/ ...
Glen, The ignition, door and glove box keys are completely different (very different blanks) for my federal +2S, I'll take a photo tonight. Russ
... found that the arrangement of all the clips to have a nice install was more ... we should bleed the master cylinder and slave. Drew wanted to look inside the ...
85. 20 year elan in a barn : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
Hi, i've just buy in february to a member of this forum a 1970 S4DHC LHD elan, the car has stood for about 20 years ...
... You can also try clamping a Jubilee clip around the cap and doing it up ... That of course means that the clutch slave may need doing, as may the ...
86. Mysterious Coolant Leak : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
My +2 has been sitting in the garage (in winter) for a few weeks now, but is suffering from an intermittant coolant leak appearing at ...
... from the heater connections, are the clips tight? Best of luck. John ... to see if its from the clutch slave cylinder-and heater systems -then run the engine ...
87. My Voigt 5-speed conversion : Drive Train / Gearbox / Final Drive - Page 6 by LotusElan.net [Drive Train / Gearbox / Final Drive]
Regarding that gearbox mounting plate, maybe you could planish a fold over using a vice and hammer. If I were you, I'd look to reinstate ...
... Elantrikbits" used to have a Video Clip which showed it well. It's difficult ... , etc. Just to ensure the slave cylinder is working, because if it ...
88. QA - Clutch +2 - LotusElan.net [Wiki]
... Fork 17 A026Q6012 (10927605B) 2 Clip - Clutch Release 18 A026Q6011 (109E7562 ... 24 050Q6005 Hose - Flexible 25 036Q6025 Slave Cylinder 26 036Q6026 Repair Kit 27 A026Q6006 ...
89. Bleeding Brakes : Suspension / Steering / Brakes / Wheels / Tyres by LotusElan.net [Classifieds]
Hey All, I want to bleed my brakes at the weekend I'll have to do it on my own and will probably use one of ...
... over the windsceen from the nipple and clip it with a clothes peg below the ... I even put one on my clutch slave. You will need 3/8 ...
90. 5 speed gearbox conversion : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I'm considering a 5 speed gearbox conversion/upgrade using the +2 box. Does anyone have any experience/opinion regarding regarding "how to" or "performance" issues? Mine's a'71 ...
... clutch plate, diaphram spring, actuator clips, clutch slave cylinder and its output ... , and the gearbox bracket are all new. Happy to help out identifying bits ...
91. Pulling the engine & transmission - Spyder Frame : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
I am partially prepped to pull the engine, and have a few questions. Some answers may vary a bit as I have an MT75 attached ...
... I had to remove some of the clips for this stuff and had minor difficulties ... stuff. Bleed the MT75 internal clutch slave cylinder prior to mounting the exhaust as ...
92. Can you recover a damaged clutch pipe? : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
After rebuilding my engine over the last two months, when anything that could go wrong usually did, it started almost immediately and ran smoothly enough ...
... . Secured with an "OTK" clip it's still in place without leaks! ... a braided hose direct from master to slave cylinder, not original but in my ...
93. Sump guard/exhaust protection : Engine / Exhaust / Cooling by LotusElan.net [Engine / Exhaust / Cooling]
Hi all Just a question to the wide world really. I've had a couple of problems with the exhaust grounding even though it's nicely wedged ...
... (and others) sell superior jubulee clip style clamps that can give you and ... clearance even more, heat the clutch slave and surrounding areas, also, there's ...
94. Best Mods : Elan Discussions - Page 2 by LotusElan.net [General]
Hi Frank Tried to pm you but I don't think it got there! Relays- I needed to find a space for 8 since 4 of ...
... these to accept what are called spire clips which basically convert a hole in thin ... in your brake and clutch master/slave cylinders, and an oil cooler. ...
95. naff ? : Elan Discussions - Page 3 by LotusElan.net [General]
Hi all, When I got the car in boxes(S4 70) the PO left it in reverse so after removing gear-leaver cover plate I pulled back ...
... Take care not to damage the star clip that holds the adjuster plug. Regards ... it might need bleeding again or the slave rod might need ajusting. kerryblu OK ...
96. 1965 S2 Elan : Lotus Elans and Plus 2's for Sale by LotusElan.net [Classifieds]
Spring time is here! Time to get out and enjoy the backroads. And what better way to enjoy springtime driving than with a 1965 Series ...
... years ago. A new-used rear fiberglass clip was glassed on by the owner at ... brakes are good. Clutch master and slave cylinders were recently rebuilt. Convertible top ...
I have done many of the mods suggested in this post with good results. Three that I do not see are: 1. Oil pressure fail ...
... galvanized wire and a couple of u clips. this is the second version, ... speed transmission I adapted a concentric clutch slave cylinder. Attachments crannyr stugilmour wrote: ...
Further to my post earlier in the week [about getting my 1973 Sprint FHC back on the road I have got my hands dirty. This ...
... next weekend and post a You Tube clip. Also got the brake and clutch ... , supply you with new master and slave cylinders, braided hoses and discs. ...
99. 1969 S4 - replacing old behind dash wiring (doh!) : Electrical / Instruments by LotusElan.net [Electrical / Instruments]
Hi folks - I haven't posted in quite a while - been pre-occupied with getting to retirement, selling a house, moving etc. I just retired ...
... an in-line fuse barrel and some alligator clips would be fine to allow you to ... time - suspension, clutch master/slave and some interior work. I've had ...
100. clutch release bearing attachment : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Following the completion of a re-build, I intended to fit the engine back into the car today. However I have spent the afternoon and evening ...
... " of the fork to bearing spring clips before I felt comfortable with their attachment ... keep an eye on the clearance (slave cylinder) fork : bearingholder (1 ...
Search took 0.149 seconds