Water Temperature Sender - what thread?
6 posts
• Page 1 of 1
HI
I believe it is 3/8" BSP. That was the thread on my sender that bolted into the head by the thermostat housing.
That was on my +2 but don't know if my head was ever modified in the past. I would wait for a further confirmation.
Hope this helps best of luck
Bob
I believe it is 3/8" BSP. That was the thread on my sender that bolted into the head by the thermostat housing.
That was on my +2 but don't know if my head was ever modified in the past. I would wait for a further confirmation.
Hope this helps best of luck
Bob
- bob_rich
- Fourth Gear
- Posts: 564
- Joined: 06 Aug 2009
Thanks for responses - my Sprint has a Smiths electrical temp gauge but sender has gone bad, so I'm trying to get a replacement.
I was wondering if the +2 sender would fit but seems not, as my thread seems to be 3/8 UNF, albeit going into an adaptor screwed into the head (which is presumably a BSP thread).
I sourced a replacement from "Smiths" but it is 1/8 NSP, so won't fit, though I'm hoping to 'convert' the thread by running a UNF die down it - crossed fingers!
I was wondering if the +2 sender would fit but seems not, as my thread seems to be 3/8 UNF, albeit going into an adaptor screwed into the head (which is presumably a BSP thread).
I sourced a replacement from "Smiths" but it is 1/8 NSP, so won't fit, though I'm hoping to 'convert' the thread by running a UNF die down it - crossed fingers!
-
mmatthej1 - Second Gear
- Posts: 143
- Joined: 20 Aug 2011
6 posts
• Page 1 of 1
Total Online:
Users browsing this forum: joe7 and 30 guests