Bad News Folks: prob. clutch release fork!! 8,5h free labor!

PostPost by: el-saturn » Sun Mar 25, 2018 5:09 pm

as the fork travels enough under "soft" pressure it's most likely a bent fork: a new reinforced one on its way from burton (my punk has the stronger pressure plate and clutch by AP, so many say i shouldv'e known this: i didn't!! so now i just need some soothing from you fellas! sandy
el-saturn
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 1374
Joined: 27 Jun 2012

PostPost by: Stevie-Heathie » Mon Mar 26, 2018 6:11 am

If it makes you feel any better my S3 needs its engine out to replace the clutch release bearing.

The good news however is that my motivation is I?ve got a place at the Lotus trackday at Goidwood on 21 April :-)))))

Anybody else on here going (suppose I?ll start a separate thread)

Steve
1967 S3 SE DHC
1970 +2S (RIP - went out in a blaze of glory in 2001)
User avatar
Stevie-Heathie
Third Gear
Third Gear
 
Posts: 484
Joined: 08 Dec 2015

PostPost by: AussieJohn » Mon Mar 26, 2018 5:11 pm

Well Sandy, it's time to take a deep breath, open the toolbox and go for it, cheers, John.
AussieJohn
Third Gear
Third Gear
 
Posts: 456
Joined: 10 Jun 2007

Total Online:

Users browsing this forum: No registered users and 16 guests