Elan Plus 2 MT75 Slave Cylinder Bleeding

PostPost by: yosini » Sun Dec 17, 2017 2:33 pm

Hello,

So, I finally got a it more 'time off' to replace the clutch master cylinder on my Plus2 - cutting the top off the pedal box made life so much easier. New cylinder in, great. Car up on axle stands, great. Can't find the slave cylinder, strange...Tracing the hydraulic pipe it travels inside the bellhousing so a bit of online reading points me in the direction of there possibly being a concentric clutch slave cylinder somewhere in there, ideally with an external bleed nipple somewhere.

With the MT75 Spyder conversions where would the best place be to start looking for this magic hidden nipple...? I've had a good look and rummage around under there but can't find anything that obvious yet.

Any pointers welcomed

Cheers

Joe
1974 Lotus Elan Plus2 130/5
1962 Daimler Dart
1968 Jensen Interceptor Mk1
1969 Rover P6 3500
1972 TVR Vixen 2500
1972 Maserati Indy 4.7
1980 VW Camper T25
1988 Toyota Hilux Pickup
1996 TVR Cerbera 4.2
2003 Smart Roadster
yosini
New-tral
 
Posts: 13
Joined: 23 Jan 2015

PostPost by: yosini » Sun Dec 17, 2017 4:43 pm

ok, search over - but I was not expecting that....for future reference and for anyone else looking in vain. It's on the opposite side to where the hydraulics enter the belhousing behind a well disguised rectangular grommet shielded partially by the exhaust. Great, now let's see if it will bleed!

Cheers

Joe
yosini
New-tral
 
Posts: 13
Joined: 23 Jan 2015

PostPost by: stugilmour » Thu Dec 21, 2017 4:25 pm

Joe, here are a couple of pictures that might help with your description. Item 1 is the hydraulic line and item 2 is the bleed stem. Note the bell housing orientation in the first picture, which shows the bleed opening is on the left side as you found out; the bell must be on it?s side in the other picture.

Here is a link to the service manual for the MT75. The Scorpio web site also has the parts diagrams. :D

http://www.fordscorpio.co.uk/manual/man ... erhaul.pdf

Question. Does yours have a rubber piece to fill the rectangular hole in the bell? Mine never had something to cover the hole, and not sure where to get something. Transmission is out righ now so would be a good time to add something.

HTH

Stu
Attachments
862b0e4a-20fd-4abb-b315-4daa11b17b88.png and
Ford MT75 bell housing orientation
5f89d540-cb26-44dc-a3b5-34ee2bdf73fd.png and
Ford MT75 concentric slave cylinder
Stu
1969 Plus 2 Federal LHD
User avatar
stugilmour
Coveted Fifth Gear
Coveted Fifth Gear
 
Posts: 2060
Joined: 03 Sep 2007

Total Online:

Users browsing this forum: No registered users and 21 guests