Bedding in rings
2 posts
• Page 1 of 1
My rebuilt engine was honed and fitted with new rings, cam bearings, big ends and mains. I have covered about 350 miles but since seeing the advice on the forum I had kept the revs below 3000 as per the handbook thinking I was being sensible!!. Is it now too late to bed the piston rings in correctly by doing a series of acceleration runs to about 4500rpm as suggested?
- William2
- Fourth Gear
- Posts: 983
- Joined: 20 Jan 2013
2 posts
• Page 1 of 1
Total Online:
Users browsing this forum: No registered users and 25 guests