Hi - does anyone have a wiring diagram for an "Aldon Ignitor" ignition system (this is the type that replaces the points within the existing distributor) they could possibly scan and post/email - or know the correct connections to make with the red and black wires? It's on a S130/5 with a ballast resistor coil.

The reason I'm asking is that the car "failed to proceed" the other day, probably because the solenoid has gone FUBAR and in trying to get the car back onto our driveway the car recovery guy played games with the ignition wires...

Any help much appreciated!

Craig

Assuming you have -ve earth:

Black wire goes to coil terminal marked -ve or "cb"

Red wire goes to the ignition +ve feed (which is the opposite side of the ballast resistor from the one that connects to the coil terminal marked +ve or "sw").

Paddy

Paddy - great stuff, thanks! (I'd lost the diagram that came with the system and was trying to work out which wires had been pulled off what in an effort to breath life on the system).

Craig

When I did mine, I spent a long while trying to get it started after replaceing with aldon (which is great, have one on my 7 as well) as you have to remember to 're-time' it first.

Thanks guys, sadly I'm back to points for the moment, dozy breakdown man managed to fry the ignitor...

All I need now is a new starter solenoid and tax and it's back on the road! C

they are called breakdown men for a reason.....

if you think experts are expensive, you should try incompetence......