Soft brake pedal: master cylinder choice 0.625/0.7/0.75 ?
Posted: Sun Jan 13, 2019 1:27 pm
Another bore question...sorry
My 64 DHC S2 had its servo removed in the past.
Brake efficiency is OK but I feel brake pedal too soft and with too much travel (std Elan caliper not+2 ones).
I have ckecked leaks, bleeding, pads: Everything OK.....I just found freeplay in pushrod: corrected but not a big improvement
I would like to know:
- If Elan fitted with or without a servo used the same MC ? which one ?
- Confirmation that going from to a smaller bore MC will make travel shorter but will need more pressure: 0.75 to 0.625 = harder pedal but less travel ?
Thanks !!
My 64 DHC S2 had its servo removed in the past.
Brake efficiency is OK but I feel brake pedal too soft and with too much travel (std Elan caliper not+2 ones).
I have ckecked leaks, bleeding, pads: Everything OK.....I just found freeplay in pushrod: corrected but not a big improvement
I would like to know:
- If Elan fitted with or without a servo used the same MC ? which one ?
- Confirmation that going from to a smaller bore MC will make travel shorter but will need more pressure: 0.75 to 0.625 = harder pedal but less travel ?
Thanks !!