Elan S4 Chassis to Body Fit
Posted: Wed Mar 13, 2019 1:46 pm
I fitted my chassis to body when the chassis was bare. Now I have the suspension fitted to the chassis with the engine and transmission installed the body does not quite fit as it did. The two tubular chassis members at the rear of the chassis are binding on the body, front edge of the boot/trunk.
With the body back off the chassis, I notice that the components (Lotacone?) at the top of the Chapman Strut project forward of the chassis by a few mm, probably 2-3mm. I suspect that this is the cause of the chassis to body fit not being as it was.
Does anyone else have this problem? If so what solution did you come to?
Richard Hawkins
With the body back off the chassis, I notice that the components (Lotacone?) at the top of the Chapman Strut project forward of the chassis by a few mm, probably 2-3mm. I suspect that this is the cause of the chassis to body fit not being as it was.
Does anyone else have this problem? If so what solution did you come to?
Richard Hawkins