Ajusa - my gasket: not oberserving the rules
Posted: Fri Jun 14, 2019 8:54 pm
i think our bruno schaffner in zurich is as renown as britains richards (?) - showed him my ajusa and he immediately say the reason for my gasket failing a) quite a bit of compression (1/4 inch dome left on the forged piistons) b) flatness of entire head (whole length in the middle -500mm) 0,02mm gap as far as i remember. in any case ill get mine there tomorrow at 8am for a 0,2 mm skim and can get it back at noon for 60quid (aint that good for one of the planets most expensive resorts sandy