Lotus Elan

Fuel banjos with Sytec linkage?

PostPost by: disquek » Mon Apr 08, 2019 2:12 am

What have folks with the Sytec linkage done for fuel banjos?

-Kyle
'70 S4 Elan - Cosworth BDP & Spyder Chassis
'62 S2 Super Seven Cosworth
disquek
Second Gear
Second Gear
 
Posts: 84
Joined: 25 Oct 2018
Location: USA - Philadelphia

PostPost by: cabc26b » Sun Apr 14, 2019 3:33 pm

For the carb with the linkage i use an Aeroquip compression fitting for the weber ( FCM1067 , i think , but double check ) - I run a short section of - 6 braided hose terminated with a -6 female to a -6 male/male/male T . you have to notch the bracket to make it work. the rest of the loom can be done with press on fittings ( otiker clamps are optional with low pressure of needed for webers) with appropriate hose.
cabc26b
Fourth Gear
Fourth Gear
 
Posts: 919
Joined: 21 Sep 2003

PostPost by: patrics » Sat Apr 20, 2019 6:54 pm

Hi
I just used normal type fittings but modified the linkage so that the banjo's could be done up.

Regards
Steve
patrics
Fourth Gear
Fourth Gear
 
Posts: 520
Joined: 21 Sep 2003

Total Online:

Users browsing this forum: USA64 and 3 guests