Page 2 of 2
Re: Emerald ECU on Zetec +2
Posted:
Mon Jun 12, 2017 3:21 pm
by pauljones
I dont have a manual and i cant open the link on my device.
They did say RTFM but damm hard if you dont have one to read.
Re: Emerald ECU on Zetec +2
Posted:
Mon Jun 12, 2017 3:45 pm
by Spyder fan
pauljones wrote:I dont have a manual and i cant open the link on my device.
They did say RTFM but damm hard if you dont have one to read.
Did they also advise you of the 7 p's of wisdom?
Pin 12 is the tacho signal output
Page grab images here
Re: Emerald ECU on Zetec +2
Posted:
Mon Jun 12, 2017 4:48 pm
by pauljones
Thanks Alan
Re: Emerald ECU on Zetec +2
Posted:
Tue Jun 13, 2017 4:29 pm
by elanman999
EMA7K,
I found it much better to email Emerald for advice, they will answer you.
Cheers
John
Re: Emerald ECU on Zetec +2
Posted:
Wed Jun 21, 2017 7:14 am
by EMA7K
John
Yes i have been in touch with Dave at Emerald. Most helpful.
I've been delayed in trying to sort this problem out due to the death of a close friend. However, i am going to attempt to sort it out on Friday. Dave has offered to have a go remotely using Team Viewer but i'm not sure the laptop i have the Emerald software on is up to coping with the internet!
I need to have a go though as being on the Wirral its a fair old trip to either Spyder or Emerald especially if i get stuck in traffic as i would have to keep blipping the throttle and appear as an ageing boy racer!
On the good side the recent good weather means that I have been using my DHC sprint (EMA7K),
I'll keep you posted.
Gareth
(EMA7K)